Brake Electric Vacuum Pump, Removing And Installing, RS 5: Installing
Install in reverse order of removal.
Use new clamps when installing the vacuum line.
-- Insert the Brake System Vacuum Pump -V192- into the bracket.
-- Press the right and left clip -arrow- into the bracket by hand and secure the Brake System Vacuum Pump -V192-.
-- Insert the bracket with the installed Brake System Vacuum Pump -V192- into the engine compartment.
Make sure it is installed in the correct position
-- Install the bracket for the Brake System Vacuum Pump -V192- on the body using two bolts -1 and 5- and tighten to 20 Nm.
-- Slide the new clamp over the vacuum hose.
-- Slide the vacuum hose over the connection for the Brake System Vacuum Pump -V192-.
Be careful not to kink or damage the vacuum hose. Replace the vacuum hose if damaged.
For easier installation, moisten the hose and connection with water.
Make sure the check valve is installed correctly. The arrow on the valve points in the direction of the pump.
-- Close the hose clamp with pliers.
-- Place the coolant pipe with the bracket on the pin.
-- Tighten the coolant pipe with the nut to 20 Nm.
-- Tighten the secondary pump hose to the bracket -4-.
-- Clip the vacuum hose into all brackets in the engine compartment.
-- Raise the vehicle.
-- Install the bracket -1- for the Brake System Vacuum Pump -V192- on the body using the bolt -2- and tighten to 20 Nm.
-- Connect the connection -3- to the Brake System Vacuum Pump -V192- -4-.
-- Clip the secondary pump hose into the bracket on the Brake System Vacuum Pump -V192-.
-- Install the wheel housing liner. Refer to WHEEL HOUSING LINER .
-- Install the left front wheel. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .
-- Lower vehicle.