Overview - Cover And Padding, Rear Seat Backrest With Rear Seat Backrest Frame Or Storage Compartment
NOTE:
The illustration only shows the structure of the right 2/3 section of the rear seat backrest. The structure of the left 1/3 section of the rear seat backrest is similar.
Fig 1: Overview Of Cover And Padding, Rear Seat Backrest With Rear Seat Backrest Frame Or Storage Compartment
- Molding
- Sewn into cover
- For engaging the cover in the backrest shell
- Cover
- Removing and installing. Refer to COVER AND PADDING, REMOVING AND INSTALLING, REAR SEAT BACKREST WITH REAR SEAT BACKREST FRAME OR STORAGE COMPARTMENT .
- Separate the cover from the padding. Refer to COVER AND PADDING, SEPARATING, BACKREST WITH COVER OR STORAGE COMPARTMENT
- Molding
- Sewn into cover
- For engaging the cover in the backrest shell
- Retaining Channel
- Sewn into cover
- For engaging the cover in the backrest shell
- Lower Padding
- Removing and installing. Refer to UPPER AND LOWER CUSHION, REMOVING AND INSTALLING, BACKREST WITH BACKREST BRACKET COVER OR STORAGE COMPARTMENT .
- Cushion
- Removing and installing. Refer to COVER AND PADDING, REMOVING AND INSTALLING, REAR SEAT BACKREST WITH REAR SEAT BACKREST FRAME OR STORAGE COMPARTMENT .
- Separate the cover from the padding. Refer to COVER AND PADDING, SEPARATING, BACKREST WITH COVER OR STORAGE COMPARTMENT
- Outer Bracket
- Backrest Shell
- Trim
- For locking
- Removing and installing. Refer to LOCKING MECHANISM TRIM, REMOVING AND INSTALLING .
- Rear Center Belt Guide
- Replace the entire belt guide if damaged.
- Removing and installing. Refer to REAR SEAT BELT GUIDE, REMOVING AND INSTALLING, CENTER REAR SEAT BELT GUIDE, FOLDING REAR SEAT BACKREST .
- Headrest Guide
- Removing and installing. Refer to HEADREST GUIDE, REMOVING AND INSTALLING .
- Inner Bracket
- Upper Padding
- Removing and installing. Refer to UPPER AND LOWER CUSHION, REMOVING AND INSTALLING, BACKREST WITH BACKREST BRACKET COVER OR STORAGE COMPARTMENT .
- Clip
- Covered in foam padding
- Clip
- Covered in foam padding
- Only with fabric covers
- Cushion Clip
- Only with leather covers
- For securing the cover to the padding
- Always replace if removed
- Install in same location as before removal
- Molding
- Sewn into cover
- For engaging the cover in the backrest shell
- Plugs
- For securing the cover
- Quantity: 2
- Molding
- Only on the backrest with a storage compartment or cover, right 2/3
- Sewn into cover
- For attaching the cover into the storage compartment cut-out or the backrest cover