All Wheel Drive Control Module -J492-, ADDITIONAL WORK AFTER REPLACING

NOTE:

Only perform the additional work only if the All Wheel Drive Control Module -J492- was replaced.

-- Connect the Vehicle Diagnostic Tester and switch on the ignition.

-- On the Vehicle Diagnostic Tester select the function 22 - Control Module, Replacing under Guided Functions in the directory 22 - AWD electronics .

Follow the instructions given by the Vehicle Diagnostic Tester exactly.

"Adapt" the installed rear final drive to the All Wheel Drive Control Module -J492- with the Vehicle Diagnostic Tester.

NOTE:

A system check will take place when the 22 - Control Module, Replacing function is complete. If malfunctions appear, then use "Guided Fault Finding" to correct them.