All Wheel Drive Clutch Valve -N445- OR All Wheel Drive Clutch Valve 2 -N446-, REMOVING AND INSTALLING, 0BE, 0BF: Installing
- The ball -5-, the guide -4- (the smaller diameter faces the spring) and the spring -3- must be installed in the housing opening -6- for the Clutch Valve -2-.
-- Coat the O-rings with ATF and install the new Clutch Valve -- with the new O-rings -arrows-.
-- Tighten the bolts -1- evenly until stop by hand. Then tighten to the tightening specification. Refer to -item 13- Bolt (See Figure).
Further installation is performed in the reverse order of the removal. Note the following.
Allocation for the Oil Pressure/Temperature Sensor -- and Clutch Valves -- connectors:
-1- = Oil Pressure/Temperature Sensor 2 -G640- Connector
-2- = Oil Pressure/Temperature Sensor -G437- Connector
-3- = All Wheel Drive Clutch Valve 2 -N446- Connector
-4- = All Wheel Drive Clutch Valve -N445- Connector
-- Attach the wiring harness bracket to the rear final drive. Refer to INSTALLING - "Position the bracket -1- on the final drive".
-- Fill the ATF in the rear final drive. Refer to ATF, FILLING, 0BE, 0BF .
-- Install the rear section of the exhaust system on the body and align it so it is free of tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .