Engine Speed Sensor -G28-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2013 Audi allroad. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Speed (RPM) Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector on the Engine Speed Sensor - G28- -2- with the Elbow Assembly Tool T10118.

NOTE:

To release the connector without the Elbow Assembly Tool T10118, push the connector against the Engine Speed Sensor - G28- and simultaneously lift up on the release tab with a thin wire hook.

-- Remove the bolt -1-.