Front Brake Disc, FN-3: Installing
Always use new bolts .
Clean the brake disc, wheel hub and contact surfaces before installing.
-- Place the brake disc on the hub.
NOTE:
When positioning the brake rotor, do not tilt it on the wheel hub.
-- Install the securing bolt -arrow- and tighten.
-- Position the front brake carrier.
-- Install the screws -5- on the front brake carrier and tighten to the tightening specification.
-- Install the front brake pads, refer to FRONT BRAKE PADS, FN-3 .
NOTE:
After replacing the brake pads, press the brake pedal firmly several times while the vehicle is stationary so that the brake pads are seated properly in their normal operating position.
-- Install the wheels.
Wheel bolt tightening specifications, refer to WHEEL BOLTS, TIGHTENING .