Electro-Mechanical Parking Brake Actuator: Removing
Ignition off.
Ignition must be switched off for at least 30 seconds when disconnecting the motor connector!
Parking brake released.
DTC memory interrogated, errors shown corrected and DTC memory erased.
-- Raise the vehicle.
-- Remove the wheels.
Ignition must be switched off for at least 30 seconds when disconnecting connector!
Clean the entire area around the connector and actuator/brake caliper.
Disconnect actuator connector -1-.
-- Remove both actuator bolts -1-.
-- Remove the actuator in the direction of the arrow.
-- Remove sealing ring with a suitable tool.
Make sure that ring groove of the seal and contact surface of parking brake actuator do not become damaged.
Do not use any tools with sharp edges.
-- Clean ring groove and contact surfaces if dirty. Only use brake cleaner.