Brake Pedal, With Manual Transmission

Special tools and workshop equipment required

Torque Wrench VAG 1410

Removing

To remove the brake pedal on vehicles with a manual transmission, the mounting bracket must be removed.

-- Remove the mounting bracket, refer to MOUNTING BRACKET, WITH MANUAL TRANSMISSION .

Remove the brake pedal on the removed mounting bracket.

-- Remove the bolt -3-.

Fig 1: Brake Pedal, Removing And Installing Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove the retainer -1- on the left side and remove the pins -5- to the right.

Courtesy of AUDI OF AMERICA, LLC

-- Remove brake pedal.

Install the Brake Pedal on the Removed Mounting Bracket

WARNING:

If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.

Fig 2: Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp sensor -10- if the brake pedal is released too quickly.

-- Slide the right retainer onto the pins.

-- Slide the pins from right to left through the axle in the brake pedal.

-- Secure the pins with the left retainer -1-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The pins must be secured with the retainers on both sides.

-- Install and tighten the bolt -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the mounting bracket, refer to MOUNTING BRACKET, WITH MANUAL TRANSMISSION .