Brake Pedal, With Automatic Transmission: Installing
If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp sensor -10- if the brake pedal is released too quickly.
-- Slide the left retainer -12- onto the pins.
-- Slide the pins from left to right through the axle in the brake pedal.
-- Secure the pins with the right retainer -5-.
The pins must be secured with the securing clips -5 and 12- on both sides.
-- Install and tighten the bolt -11-.
Clip the brake pedal to the brake booster.
-- Hold the push rod ball head in front of the mount and push the brake pedal toward the brake booster, so that the ball head clicks into place.
-- Install the brake lamp sensor, refer to BRAKE LAMP SENSOR .
-- Install the footwell vents -A-B-.
-- Tighten the footwell vent screw -A-.
-- Connect the electrical connector to the footwell vent -C-.
-- Install the driver side instrument panel cover -1 to 3-.