Brake Booster Plunger Mount: Installing

-- Insert the brake booster mount and ball socket in the brake pedal.

The mount must engage audibly.

Clip the brake pedal to the brake booster.

-- Hold the push rod ball head in front of the mount and push the brake pedal toward the brake booster, so that the ball head clicks into place.

-- Install the brake lamp sensor, refer to BRAKE LAMP SENSOR .

-- Install the footwell vents -A-B-.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the footwell vent screw -A-.

-- Connect the electrical connector to the footwell vent -C-.

-- Install the driver side instrument panel cover -1 to 3-.

Courtesy of AUDI OF AMERICA, LLC