Brake Pedal And Mounting Bracket
WARNING:
The path of the brake pedal must not be shortened via extra floor mats.
- Lubricate all bearing and contact surfaces with lubricant part no. Lubricant G 000 450 02.
- Mounting Bracket for Pedal Assembly
- Illustration for vehicles with automatic transmission.
- Removing and Installing, with Manual Transmission, refer to MOUNTING BRACKET, WITH MANUAL TRANSMISSION .
- Removing and Installing, with Automatic Transmission, refer to MOUNTING BRACKET, WITH AUTOMATIC TRANSMISSION .
- Sleeve
- Brake Pedal Axle
- Bearing Pin
- Right Securing Clip (spring steel)
- Washer
- Gas Pedal Module Bolt
- 8 Nm
- Accelerator Pedal Module
- Pedal Support Bolt
- 20 Nm
- Brake Lamp Sensor
- Removing and Installing, refer to BRAKE LAMP SENSOR .
- Mounting Pin Bolt
- 8 Nm
- The bolt holds the mounting pins in position.
- Left Securing Clip (Spring Steel)
- Brake Pedal
- Removing and Installing, with Manual Transmission, refer to BRAKE PEDAL, WITH MANUAL TRANSMISSION .
- Removing and Installing, with Automatic Transmission, refer to BRAKE PEDAL, WITH AUTOMATIC TRANSMISSION .WARNING:
If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.
- Ball Socket Formed in Mount
- For the ball head on the brake booster push rod
- Mount
- For the ball head on the brake booster push rod.
- with ball stud retaining tabs.
- Removing and Installing, refer to BRAKE BOOSTER PLUNGER MOUNT .
- Nut
- 8 Nm
- StopWARNING:
If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.
- Grommet
- Only installed on vehicles with automatic transmission.