Overview - Rear Brakes

NOTE:

Only install complete repair kit.

Fig 1: Overview Of Rear Brake Components

Courtesy of AUDI OF AMERICA, LLC

Self-Locking Bolt
- 12 Nm
Electromechanical Parking Brake Actuator
- Refer to Electromechanical Parking Brake Control Module -J540-, REMOVING AND INSTALLING
- Refer to LEFT/RIGHT PARKING BRAKE MOTOR -V282- / -V283-, REMOVING AND INSTALLING
Seal
- Always replace.
Self-Locking Bolt
- 35 Nm
- Always replace.
- When loosening and tightening, counter-hold at guide pin
Spacer
Brake Hose
- To brake caliper: 20 Nm
- Do not disconnect brake line when changing brake pads
- Make sure that retaining tabs are seated correctly in bracket.
- Install hose without twisting
Brake Caliper Housing
- Do not remove the brake hose when changing the brake pads.
- Brake Caliper, Servicing
- It is possible to install brake carrier with brake caliper
- Refer to BRAKE CALIPER, REMOVING AND INSTALLING
- Refer to BRAKE CALIPER, REPLACING
Brake Carrier with Guide Pins and Cap
- Supplied as an assembled replacement part with sufficient grease on guide pins.
- Install the repair kit if the caps or guide pins are damaged. Use supplied grease packet to lubricate guide pins.
- It is possible to install brake carrier with brake caliper
- Removing and installing. Refer to BRAKE CALIPER, REMOVING AND INSTALLING .
Brake Pads
- Always replace on both axles.
- Refer to BRAKE PADS, REMOVING AND INSTALLING
- Check the brake pad thickness.
- It is possible to install brake carrier with brake caliper
  NOTE:
  The brake pads must be seated between both securing tabs on the brake pad retaining plate to provide the air gap between the brake rotor and brake pad.
Brake Pad Retaining Plate
- Always replace when pads are replaced
  NOTE:
  The brake pads must be seated between both securing tabs on the brake pad retaining plate to provide the air gap between the brake rotor and brake pad.
Wheel Bolts
- Install the wheels. Refer to WHEEL, CHANGING AND MOUNTING .
Bolt
- 5 Nm
Brake Rotor
- Wear limit. Refer to BRAKE PR NUMBERS .
- Always replace on both axles.
- Refer to BRAKE ROTOR, REMOVING AND INSTALLING, BRAKE PADS IN PLACE
- Refer to BRAKE ROTOR, REPLACING, BRAKE PADS REMOVED
Hex Head Bolts
- 10 Nm
Brake Shield
- Refer to BRAKE SHIELD, REMOVING AND INSTALLING
Bolt
- 100 Nm + 90°
- Replace
Bolts
- 100 Nm + 90°
- Replace

NOTE:

Close the bleed screw and tighten to 13 Nm.