Brake Caliper, FBC
NOTE:
Install complete repair kit when servicing.
Apply thin coat of assembly paste G 052 150 A2 to brake cylinders, pistons and seals.
- 1 -Bolt
- 30 Nm
- 2 -Cap
- Insert in brake caliper.
- Replacing, refer to PROTECTIVE CAP AND GUIDE PINS, FBC BRAKES .
- 3 -Guide Pins
- Slide through the boot.
- Replacing, refer to PROTECTIVE CAP AND GUIDE PINS, FBC BRAKES .
- 4 -Cap
- Install on the bleeder valve.
- 5 -Bleeder Valve
- Apply a thin coat of assembly paste G 052 150 A2 to the threads before screwing in.
- 15 Nm
- 6 -Brake Caliper Housing
- 7 -Spring
- Ensure installation position is correct.
- 8 -Cap
- Do not damage when installing piston.
- coat with Assembly Paste G 052 150 A2
- 9 -Pistons
- First apply thin coat of brake cylinder paste G 052 150 A2 on piston.
- Diameter 57 mm.
- 10 -Seal
- Coat with assembly paste G 052 150 A2.
- 11 -Brake Carrier
- Removing and Installing, refer to BRAKE CALIPER WITH FRONT BRAKE CARRIER, FBC-57 .
- The 4 retaining pins for the brake pads on the brake carrier must not be loosened under any circumstances.
- 12 -Bolt
- 196 Nm