Overview - Rear Brake Caliper
NOTE:
When servicing, always install entire repair kit.
Apply thin coat of Assembly Paste G 052 150 A2 to brake cylinders, pistons and seals.
- 1 -Self-Locking Screw
- 35 Nm
- Always replace.
- Counterhold at the guide pin when loosening and tightening.
- 2 -Brake Caliper Housing with Actuator
- 3 -Bleeder Valve
- 13 Nm
- 4 -Dust Cap
- Push onto bleed valve
- 5 -Seal
- Removing and installing. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING .
- 6 -Pressure Nut
- To operate parking brake
- 7 -Piston
- Removing and installing. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING .
- 8 -Guide Pin
- Grease before pulling on protective cap
- Delivered as a replacement part with sufficient grease.
- Replacing. Refer to BEARING BUSHING AND GUIDE PIN, REPLACING .
- 9 -Protective Cap
- Pull onto the brake carrier and guide pin.
- Replacing. Refer to BEARING BUSHING AND GUIDE PIN, REPLACING .
- 10 -Brake Carrier with Guide Pins and Cap
- Supplied as an assembled replacement part with sufficient grease on guide pins.
- Install the repair kit if the protective caps or guide pins are damaged. Use supplied grease packet to lubricate guide pins.
- 11 -Protective Cap
- Removing and installing. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING .
- Pull onto the piston with the outer sealing lip.