Overview - Rear Lid, AVANT
- Gas-Filled Strut
- Noise insulation component must be installed on the body side.
- Lid Hinge
- Removing. Refer to HINGES, REMOVING AND INSTALLING, AVANT .
- Motor in Rear Lid Control Module -V375-
- Rear Lid
- Removing:
- Remove the trim panel from the rear lid. Refer to UPPER REAR LID TRIM PANEL, REMOVING AND INSTALLING and LOWER REAR LID TRIM PANEL, REMOVING AND INSTALLING
- Disconnect the connectors and disconnect the hose for the rear window washer system.NOTE:
Remove rear lid motors on vehicles equipped with a power rear lid release. Refer to OVERVIEW - REAR LID MOTOR .
- A second technician will be needed to hold and to lift the rear lid.
- Pull the gas-filled struts off the rear lid.
- Remove the bolts from the left and right hinges on the rear lid.
- Remove the rear lid.
- Cover
- Lid Latch
- Removing. Refer to HOOD LATCH, REMOVING AND INSTALLING, AVANT .
- Cover
- Nuts
- 21 Nm
- Seal
- Removing and installing. Refer to REAR LID SEAL, REMOVING AND INSTALLING, AVANT .
- Adjusting Buffer
- Adjusting. Refer to REAR LID, ADJUSTING, AVANT - "Adjusting Buffer Installed Position" (See Figure).
- Bolts
- 8 Nm
- Catch
- Note different versions.
- Nut
- 21 Nm
- Stop
- Bolt
- 8 Nm