Overview - Bumper Cover, AUDI RS 4

CAUTION:

Note the following for vehicles with lane change assist.

If rear bumper is removed and re-installed or changes are made to bumper, lane change assist (Audi side assist) calibration is necessary. Refer to LANE CHANGE ASSISTANCE, CALIBRATING .

Courtesy of AUDI OF AMERICA, LLC

Rear Bumper Cover
- Removing and installing. Refer to BUMPER COVER, REMOVING AND INSTALLING, AUDI RS 4 .
Mount
- For the tail pipe trim
- Mounted using 8 clips
- Removing and installing. Refer to ATTACHMENTS, REMOVING AND INSTALLING, AUDI RS 4 .
Bolt
- 2 Nm
- Quantity: 4
Tail Pipe Trim
- Removing and installing. Refer to ATTACHMENTS, REMOVING AND INSTALLING, AUDI RS 4 .
Bolt
- Quantity: 3
- Tightening sequence. Refer to 16
Guide Piece
- For the bumper cover
- Removing and installing. Refer to BUMPER GUIDES, REMOVING AND INSTALLING, AUDI RS 4 .
Upper Guide Piece
- To the bumper cover retainer
- Removing and installing. Refer to BUMPER GUIDES, REMOVING AND INSTALLING, AUDI RS 4 .
Retainer Pin
- For the bumper cover
Bolt
- 2 Nm
Bolt
- Tightening specification. .
Lane Change Assistance Control Module
- Removing and installing. Refer to LANE CHANGE ASSISTANCE CONTROL MODULE -J769- / LANE CHANGE ASSISTANCE CONTROL MODULE 2 -J770-, REMOVING AND INSTALLING, AUDI RS 4 .
Center Guide
- For the bumper cover
- Removing and installing. Refer to BUMPER GUIDES, REMOVING AND INSTALLING, AUDI RS 4 .
Bolt
- Quantity: 2
- Tightening sequence. Refer to 16
Cap
Nut
- 4 Nm
Cap
- For the towing eye

Fig 1: Guide and Bumper Cover Retainer Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts to 2.0 Nm in a -1 to 3- sequence.

Fig 2: Bumper Cover Center Guide Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts to 2.5 Nm in the sequence -1 to 2-.