Bumper Cover, Removing And Installing, AUDI RS 4: Removing

Courtesy of AUDI OF AMERICA, LLC

-- Remove the tail lamps. Refer to TAIL LAMP, REMOVING AND INSTALLING .

-- Disconnect the central connector -1-.

-- Press the grommet -2- outward.

-- Remove the cover.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -2-.

-- Remove the bolts -1- on the lower bumper cover section.

-- Remove the bolts -arrows- and press the wheel housing liner -1- to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2-.

-- Remove the retaining pin -2- upward in direction of -arrow A-.

-- Remove the left and right bumper cover side pieces on the side panel in direction of -arrow B-.

-- Remove the bumper cover -1-. When doing this, the wiring harness must also be guided out from the vehicle body pass through.

Courtesy of AUDI OF AMERICA, LLC