Overview - Bumper Cover, ALLROAD: Notes
NOTE:
Only the differences from the standard bumper are described
The removal and installation of the bumper cover is performed like that of the standard bumper.
- Right Bumper Cover
- Removing. Refer to "Remove the Left and Right Bumper Cover" (See Figure).
- Radiator Grille
- Removing and installing. Refer to RADIATOR GRILLE, REMOVING AND INSTALLING, EXCEPT AUDI RS 4 .
- Loosen the bolts. Refer to "Loosen the Radiator Grille". (See Figure).
- Bolt
- 1.5 Nm
- Bolt
- 4 Nm
- Left Bumper Cover
- Removing. Refer to "Remove the Left and Right Bumper Cover" (See Figure).
- Left Air Intake Grille
- Front Spoiler
- Unlike for standard bumpers, the two left and right expanding clips must be removed first, before the front spoiler can be removed. Refer to "Expanding Clip for Front Spoiler" (See Expanding Clip for Front Spoiler: ).
- End Plate
- Bumper cover removed. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Remove the bolts -12- and remove the end plate from the impact guard toward the rear.
- Bumper cover removed. Refer to BUMPER COVER, REMOVING AND INSTALLING .
- Bolt
- 1.5 Nm
- Impact Guard
- Bumper cover removed
- Remove bolts -12- and bolt -11- and remove impact guard from the front spoiler and end plate toward the front.
- Bolt
- 1.5 Nm
- Bolt
- 1.5 Nm
- Right Air Intake Grille