Bumper Cover, Removing And Installing, Standard, ALLROAD: Removing

Courtesy of AUDI OF AMERICA, LLC

-- Remove the lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .

-- Disconnect the electrical connector -2- for the Outside Air Temperature Sensor -G17- and the electrical connector -1- for the front parking aid sensor.

NOTE:

Additional connectors may need to be disconnected, depending on vehicle equipment.

-- Remove the bolt -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and the quick-release coupling -1- on the front bumper noise insulation.

-- Remove the wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Disconnect the electrical connector -1- on the fog lamp.

-- Remove the bolts -arrows-.

NOTE:

Only the upper bolt is installed from MY 2013.

-- Disengage the side walls on the front side panel and remove the bumper cover forward.

Courtesy of AUDI OF AMERICA, LLC