End Panel, Removing And Installing

Fig 1: Identifying End plate Components

Courtesy of AUDI OF AMERICA, LLC

1. Fender
2. End Plate

   -- Remove front wheel.

   -- Remove the rear part from the wheel housing liner. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER, EXCEPT AUDI RS 4 .

   • Loosen the windshield washer fluid reservoir on the left side

     -- Remove the bolts -3-, unclip the end plate from the fender rear bracket and slide it downward. Refer to "FENDER, REMOVING AND INSTALLING" -item  6- Rear Bracket (See Figure).

3. Bolts
   • 1.5 Nm
4. Clip
   • Quantity: 2

Unclip the End Plate

Fig 2: Identifying End Plate Components

Courtesy of AUDI OF AMERICA, LLC

-- Before the end plate -1- can be removed downward, it must first be unclipped from the bracket -arrow- for the fender -2-.