Fuel Rail

WARNING: This page is about a different variant/trim than selected.

If the fuel filter is being replaced, then the intake manifold runner position sensor -G336- must be adapted to the engine control module -J623- Vehicle Diagnosis and Service SystemVAS 5052 "Guided Functions"

NOTE:

Intake manifold must be removed. Refer to INTAKE MANIFOLD WITH FUEL RAIL .

-- Remove hoses from EVAP canister.

-- To do so, open hose clamp -1-.

-- Loosen two bolts -arrows- of fuel rail.

Fig 1: Identifying Hose Clamp & Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Pull hose connection -1- off from intake manifold and remove both bolts -arrows-.

-- Open both fuel lines -2 and 3-.

Fig 2: Fuel Lines & Intake Flap Motor V157

Courtesy of AUDI OF AMERICA, LLC

-- Carefully pry off linkage from Intake Flap Motor -V157- -4-.

-- Remove Intake Flap Motor -V157- -5-.

Fig 3: Fuel Lines & Intake Flap Motor V157

Courtesy of AUDI OF AMERICA, LLC

-- Pry fuel rail off from the intake manifold via the retaining tabs -arrows-.

Fig 4: Identifying Fuel Rail From Intake Manifold

Courtesy of AUDI OF AMERICA, LLC

-- Remove fuel rail from intake manifold.

Installing

-- Installation is in reverse order of removal.

-- Intake manifold, installing. Refer to INTAKE MANIFOLD WITH FUEL RAIL .