Pulling Off Synchronizer Hub/Operating Sleeve For 3RD And 4TH Gear With Gear Wheel For 4TH Gear

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Puller/Separator Assembly To Pull Off 3rd And 4th Gear Synchro-Hub/Locking Collar Over 4th Gear Wheel

Courtesy of AUDI OF AMERICA, LLC

-- Before pulling off, remove circlip.

A - Extractor, for example Kukko 18/2

B - Separating device 22 to 115 mm, for example Kukko 17/2