Assembling Locking Collar/Synchronizer Hub For 1ST And 2ND Gears As Well As 3RD And 4TH Gears

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Assembling 1St And 2Nd As Well As 3Rd And 4Th Gear Locking Collar/Synchro-Hub

Courtesy of AUDI OF AMERICA, LLC

The locking collar is pushed over the synchronizer hub.

-- Insert locking pieces and install the springs 120° offset.

Spring must engage with angled end into hollow engaging piece.