Removing The Grooved Ball Bearing
WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove circlip from input shaft.
-- Before attaching extractor, place VW 431 and 40 - 105 on input shaft.
-- Attach separating device -B- into surrounding groove for circlip in bearing.
A - Extractor, for example Kukko 18/1
B - Separating device 12 to 75 mm, for example Kukko 17/1