Installation Position Of Clutch Plate

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Marking Getriebeseite -arrow- (transmission side) and the projecting spring cage faces toward transmission.

Fig 1: Installation Position Of Clutch Disc At Dual-Mass Flywheel
Courtesy of AUDI OF AMERICA, LLC

-- Insert 3067.

Fig 2: Identifying Flywheel Retainer 3067 Repositioned For Installation

Courtesy of AUDI OF AMERICA, LLC

-- Position the pressure plate on the alignment pins.

-- To center the clutch plate, use the T10097.

Install the pressure plate as follows so that the pressure plate does not distort during installation (causing shuddering during acceleration):

-- Make sure that the stop pin (locator) -arrow- can be moved easily.

Fig 3: Checking Stop Pin (Position Sensor)

Courtesy of AUDI OF AMERICA, LLC

-- Install all 6 bolts evenly, by hand, until the bolt heads contact the pressure plate.

-- Tighten all 6 bolts clockwise, one after the other and in steps of 90° (¹ /₄ turn) until the housing contacts the flywheel.

When doing this, the stop pin -arrow- must lift off from the pressure plate.

-- Tighten all 6 bolts clockwise, one after the other to tightening specification. Tightening specification -4- SACHS CLUTCH ASSEMBLY OVERVIEW .