Needle Bearing From Crankshafts

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Puller T10055
With Adapter T10055/3
Centering Mandrel 3176
or Drift VW 207 C
Extractor for example Kukko 21/2

Removing

-- Pull out using standard extractor for example Kukko 21/2 -arrow-, T10055/3 and T10055.

Fig 1: Identifying Standard Extractor E.G. Kukko 21/2, Adapter T10055/3 And Puller T10055

Courtesy of AUDI OF AMERICA, LLC

Installing

NOTE:

Side of needle bearing with writing on it must be readable when installed.

-- Drive in using the VW 207 C or 3176.

Fig 2: Driving In Needle Bearing Using Drift VW 207 C

Courtesy of AUDI OF AMERICA, LLC

Installation depth dimension -a- = 2 mm

Fig 3: Identifying Installation Depth Dimension

Courtesy of AUDI OF AMERICA, LLC