Lower Timing Chain Cover, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi A6 Quattro, 2014 Audi A6 Quattro, 2013 Audi A6, and 2012 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

Transmission removed, refer to TRANSMISSION, REMOVING .
Engine oil is drained, appropriate FLUID CAPACITY information .

NOTE:

When installing, bring all cable ties back to same positions.

-- Remove the upper coolant pipe, refer to UPPER COOLANT PIPE, REMOVING AND INSTALLING .

-- Remove the drive plate, refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Remove the left and right timing chain guards, refer to LEFT AND RIGHT TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Remove the oil filter housing, refer to OIL FILTER HOUSING, REMOVING AND INSTALLING .

-- Disconnect the starter connector -3- by sliding the retainer back and pressing the release down.

Fig 1: Disconnecting Starter Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the electrical wire nut -2- and starter.

NOTE:

Ignore items -1 and 4-.

-- Remove the bolts -arrows-.

-- Loosen and remove the bolts -1 through 10- in a diagonal sequence.

-- Carefully loosen the lower timing chain cover from the bond and remove it.

-- Press the transmission side of the crankshaft shaft seal out of the lower timing chain cover.

Fig 2: Identifying Lower Timing Chain Cover Bolt, Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC