LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> S6 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1887 (3.0L - Cylinder Head & VALVETRAIN - Engine Code(S): CGXB & CTUA) >> 15 Cylinder Head, VALVETRAIN >> Cylinder Head >> Cylinder Head Cover, Removing And Installing >> Right Cylinder Head Cover, Removing And Installing >> Installing

Right Cylinder Head Cover, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A6 Quattro, 2014 Audi A6 Quattro, 2013 Audi A6, and 2012 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the cylinder head seal if it is damaged.

Replace the cylinder head cover bolts when replacing the damaged seal.

Replace the O-ring.

-- Clean any oil or grease off the sealing surfaces.

-- Tighten the right cylinder head cover bolts, refer to Figure.

-- Install the air filter housing, refer to AIR FILTER HOUSING .

-- Install the ignition coils, refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals