Valve Timing, Checking

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Dial Gauge Adapter T10170A
Dial Gauge Set VAS 6341

-- Remove the upper timing chain cover, refer to UPPER TIMING CHAIN COVER .

-- Remove the noise insulation -1-, refer to NOISE INSULATION OVERVIEW .

Fig 1: Locating Noise Insulation

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Turn the crankshaft with the socket SW 24 on the vibration damper in the direction of the engine rotation until the markings -arrows- are almost on top.

Fig 2: Identifying Mark Points On Intake And Exhaust Camshafts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the spark plug from cylinder 1.

-- Install the Dial Gauge Adapter T10170/A all the way into the spark plug thread.

Fig 3: Identifying Adapter For Dial Gauge

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the Dial Gauge Set VAS 6341 using the Dial Gauge Adapter - Extension T10170A/1 until stop and secure with the locking nut -arrow-.

-- Turn the crankshaft slowly in the direction of the engine rotation until the maximum dial reading is reached. When the maximum dial reading is reached (BDC of the meter) position the piston at "TCD".

NOTE:

Use a ratchet with a 24 mm socket to turn the vibration damper.

If the crankshaft was turned past "TCD", turn the crankshaft two more turns in the direction of the engine rotation. Do not turn the engine in the opposite direction of the engine rotation.

The notch on the vibration damper must line up with the arrow marking on the timing chain lower cover -arrow-.

Fig 4: Identifying Vibration Damper With Counterhold - Vibration Damper T10355
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
The markings -1- on the camshaft chain sprockets must be opposite the markings -2- and -3- on the cylinder head.