LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> S6 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1625 (1.8L, 2.0L & 2.5L - Fuel Supply - Engine Code(S): CBTA, CBUA, CCTA, CPKA, CPLA, CPPA & CPRA (Convertible)) >> 20 Fuel Supply >> Removal And Installation >> Fuel Level Sensor -G- >> Removing

Fuel Level Sensor -G-: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the fuel delivery unit. Refer to FUEL DELIVERY UNIT .

-- Move the Fuel Level Sensor -G- slightly to the side and upward at the same time.

Fig 1: Identifying Fuel Level Sensor G Pulled Slightly To Side And Simultaneously Upward
GWWN20-10175Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the tabs -arrows- slightly to the side if the sensor does not unlock.

Fig 2: Fuel Level Sensor Electrical Wires
GWWA20-10067Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Write down the colors of the cables for installing later.

-- Disconnect the connectors -1 through 3- and bend back the hooks on the connector.

Fig 3: Fuel Level Sensor Electrical Connectors
GWWA20-10431Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.