Accelerator Pedal Module -GX2-: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the connector -1- to the accelerator pedal module -4-.

Fig 1: Accelerator Pedal Module, Connector, Cap, Bolt, Retaining Pins & Centering Pin

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the accelerator pedal module onto the bolt -5-.

-- Insert the centering pin -6- into the hole in the floor panel.

-- Secure the accelerator pedal module with the bolt -2-.

-- Install the cap -3-.

-- Install the steering column cover -arrows-.

Fig 2: Identifying Steering Column Cover

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If the accelerator pedal module was replaced, adapt it to the engine control module using the Vehicle Diagnostic Tester in "Guided Functions".

-- If the accelerator pedal module was replaced on vehicles with an automatic transmission, then the kick-down function must be adapted using the Vehicle Diagnostic Tester in "Guided Functions".