LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> S6 >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels (Hood, Lids) >> 55 Hood, Lids >> Hood >> Hood, Adjusting

Hood, Adjusting

Special tools and workshop equipment required 

Gap Dimensions for Hood

Fig 1: Identifying Hood Adjustment
GWWA57-10657Courtesy of AUDI OF AMERICA, LLC
NOTE:

All dimensions are in mm with a ± 0.5 mm tolerance.

Height Adjustment Stop Buffer

Fig 2: Identifying Height Adjustment Stop Buffer
GWWA55-10705Courtesy of AUDI OF AMERICA, LLC
  1. Stop Buffer
    • The stop buffer -1- also works as a strike guard.
  2. Hood
  3. Adjusting Buffer
    NOTE:

    The adjusting buffers -2- are used to adjust the height of the hood.

    • The adjusting buffer -2- must lightly contact the lock carrier when the hood is closed.

Hood Impact Guard, Replacing

NOTE:

The impact guard is also equipped with double-sided adhesive tape.

Fig 3: Identifying Hood Impact Guard
GWWA55-10751Courtesy of AUDI OF AMERICA, LLC
  1. Clip
  2. Impact Guard
    • To remove, remove the clip from the hood and then remove the impact guard.
  3. Door

Hold Panel

Fig 4: Identifying Hood Panel
GWWA55-10762Courtesy of AUDI OF AMERICA, LLC
  1. Clip
  2. Hold Panel
    • Installation: 

      -- Slide the lining over the tabs on the rear edge into the holes provided on the inner panel.

      -- Slide the tabs on the front edge and the sides into place.

      -- The clips must engage audibly when pressing in.

      -- Press the clip in.

  3. Door
  4. Clip
scientia non olet · About LEMON Manuals