Input Shaft Ball Bearing, Replacing: Installing

Fig 1: Identifying Dual Clutch Cover, Thrust Washer And Ball Bearing

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Replace the O-ring and locking rings. Refer to OVERVIEW - FLYWHEEL AND DUAL CLUTCH .

-- If it was there during the removal, then insert a thrust washer -2- into the cover -1-.

-- Install the new dual clutch ball bearing all the way.

Fig 2: Identifying Dual Clutch Ball Bearing, Installation

Courtesy of AUDI OF AMERICA, LLC

• Position the Press Piece - 60mm VW415A with the thin shoulder facing up.

-- Install the new ball bearing circlip -arrow-.

Fig 3: Identifying Locking Ring

Courtesy of AUDI OF AMERICA, LLC

-- Clean the sealing surface on the clutch cover.