LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> S4 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Final Drive, Differential - Rear Final Drive 0BF & 0BE (Coupe)) >> Final Drive, Differential >> Removal And Installation >> Flange Shaft Seals, Rear Final Drive Removed >> Removing

Flange Shaft Seals, Rear Final Drive Removed: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2015 Audi RS 5, and 2014 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Follow the general repair instructions. Refer to the appropriate service information.

-- Remove rear final drive. Refer to REAR FINAL DRIVE .

-- Remove the flange shaft bolt. While doing this, install the two bolts into the flange counter hold the flange shaft using a tire iron.

Fig 1: Identifying Flange Shaft Bolt, Removal
GWWA39-10380Courtesy of AUDI OF AMERICA, LLC

-- Remove the flange shaft.

NOTE:

Use the VW 771 to remove the flange shaft if it is not possible to remove it manually.

-- Remove the flange shaft seal using the VW 771 and the additional part for the slide Hammer VW 771/37.

Fig 2: Identifying Flange Shaft Seal, Removal
GWWA39-10381Courtesy of AUDI OF AMERICA, LLC