Left Retaining Plate With FOOTWELL Door Motor -V261-, Disassembling And Assembling

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove The Left Retaining Plate With The Footwell Door Motor -V261-. Refer To LEFT RETAINING PLATE WITH FOOTWELL DOOR MOTOR -V261-, REMOVING AND INSTALLING .

NOTE:

The Retaining Plate With The Footwell Door Motor -V261- Is Only Installed On Vehicles Equipped With The "Basis" A/C System.

Currently In This Vehicle, All Actuators Are Identical In Construction. During The Basic Setting, The Actuators Are Assigned And Adapted Corresponding To The Switching Sequence Of The Wiring. If This Sequence Does Not Conform The Specification, The Adjustment Motors Will Adapt Incorrectly And The Door Control Will Be Wrong. Refer To MAIN WIRING DIAGRAM FOR A/C SYSTEM ACTUATORS .

The Actuator Shaft Does Not Have A Stop; Therefore The Shaft Of These Actuators Can Be Inserted Into The Curved Washer In Any Position.

Depending On The Production Date, There Are Different Versions Of The Levers And Connecting Elements On The A/C Unit. Refer To LEVERS AND CONNECTING ELEMENTS ON THE A/C UNIT

Fig 1: Depending On Production Date, There Are Different Versions Of Levers And Connections On A/C Unit

Courtesy of AUDI OF AMERICA, LLC

Bolt
Footwell Door Motor -V261-
Retaining Plate
Connecting Rod
- To The Doors For The Left And Right Instrument Panel Vents
Actuating Lever
Curved Washer
- On The Footwell Door Motor -V261-
Actuating Lever
Connecting Rod
- To The Flaps For The Rear Footwell Vents
Connecting Rod
- To The Doors For The Front Footwell Vents
Curved Washer Stop