LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> S4 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 1190 (Crankshaft, Cylinder Block (Servicing) [CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB, CHJA, CPEA] (Coupe)) >> Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Overview - Cylinder Block, Belt Pulley Side >> Overview - Cylinder Block, Belt Pulley Side, Vehicles With Hydraulic Power Steering >> Notes

Overview - Cylinder Block, Belt Pulley Side, Vehicles With Hydraulic Power Steering: Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cylinder Block, Belt Pulley Side, Vehicles With Hydraulic Power Steering Exploded View
GWWA13-10639Courtesy of AUDI OF AMERICA, LLC
  1. Ribbed Belt
    • Check for wear
    • Do not kink
    • Before removing, mark the running direction using chalk or a felt-tip pen.
    • Removing and installing. Refer to RIBBED BELT, REMOVING AND INSTALLING, VEHICLES WITH HYDRAULIC POWER STEERING 
    • Ribbed belt routing. Refer to appropriate service information.the appropriate Service Information .
    • When installing, make sure it is seated correctly on the belt pulleys
  2. Idler Roller
    • 20 Nm
  3. Bolt
    • 150 Nm + 90°
    • Always replace after removing
    • Use the Counterhold - Vibration Damper :T10355  to loosen and tighten
    • Coat the O-ring with engine oil
  4. O-ring
  5. Vibration Damper
  6. Bolt
    • 40 Nm
  7. Ribbed Belt Tensioner
  8. Sub-Assembly Bracket
  9. Generator
    • Removing and installing. Refer to GENERATOR .
  10. Bolt
    • Tightening specification. Refer to GENERATOR .
  11. Bolt
    • Tightening sequence. Refer to appropriate service information. .
  12. Bolt
  13. Sleeve
  14. Power Steering Pump
  15. A/C Compressor
    • Do not remove or disconnect the refrigerant lines
    • Removing and installing. Refer to A/C COMPRESSOR .
  16. Bolt
  17. Alignment Sleeve
    • For the A/C compressor
    • Quantity: 2
  18. Bolt
GWWA13-10638Courtesy of AUDI OF AMERICA, LLC
  1. Vibration Damper
  2. Idler Roller
  3. Ribbed Belt Tensioner
  4. Generator
  5. Power Steering Pump
  6. A/C Compressor
scientia non olet · About LEMON Manuals