Sensor Wheel, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Always replace the sensor wheel -2- each time the bolts -1- are loosened.
TIP:
After tightening a second time, the attachment point of the countersunk bolts in the sensor wheel is so deformed that the bolt heads are at the crankshaft -3- -arrows- and the sensor wheel is loose under the bolts.
- Installation of sensor wheel is only possible in one position - the bores are offset.
-- Install the balance shaft timing chain. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .
-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
-- If the sensor wheel was replaced, perform an "adaptation". Refer to Vehicle Diagnostic Tester in Guided Functions .