Overview - Balance Shaft
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Always replace after removing
- Balance Shaft
- Always replace after removing
- Intake side
- Lubricate the bearing with engine oil
- Replacing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, INTAKE SIDE .
- Balance Shaft
- Always replace after removing
- Exhaust side
- Lubricate the bearing with engine oil
- Replacing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, EXHAUST SIDE .
- Bolt
- 9 Nm
- Always replace after removing
- Balance Shaft Pipe
- Installation position. Refer to appropriate service information. .
- Exhaust Side Balance Shaft Seal
- Replacing. Refer to BALANCE SHAFT GASKET, REPLACING, INTAKE SIDE .
- The pin from the balance shaft pipe must fit into the groove -arrow-.