Brake Electric Vacuum Pump, Removing And Installing, RS 5: Removing
The electric vacuum pump is located in the engine compartment on the left side.
-- Raise the vehicle.
-- Remove the left front wheel.
-- Remove the left front wheel housing liner. Refer to WHEEL HOUSING LINER .
View of the Brake System Vacuum Pump -V192- from below after removing the wheel housing liner
-- Disconnect the connector -3- to the Brake System Vacuum Pump -V192-.
-- Remove the bolt from the bracket -2- for the Brake System Vacuum Pump -V192-.
-- Unclip the secondary pump hose from the bracket for the Brake System Vacuum Pump -V192-.
-- Lower vehicle.
View of Brake System Vacuum Pump -V192- in the engine compartment on the left side and in the front
-- Remove the secondary pump hose from the bracket -4-.
-- Push the secondary pump hose to the side.
-- Remove the nut from the coolant pipe bracket.
-- Lightly push the coolant pipe to the side.
-- Remove the two bolts -1 and 5- from the bracket for the Brake System Vacuum Pump -V192-.
-- Unclip the vacuum hose to the Brake System Vacuum Pump -V192- from the brackets in the engine compartment.
Be careful not to kink or damage the vacuum hose. Replace the vacuum hose if damaged.
-- Open the hose clamp on the vacuum hose using suitable pliers.
-- Pull the vacuum hose from the Brake System Vacuum Pump -V192-.
-- Remove the Brake System Vacuum Pump -V192- with the bracket from the engine compartment.
-- Remove the Brake System Vacuum Pump -V192- from the bracket.
-- Press the right and lift clips -arrow- out of the bracket by hand.
-- Remove the electrical vacuum pump upward while holding the rubber buffer securely.