Brake Fluid Reservoir, Removing And Installing: Removing
-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .
-- Disconnect the connector from the Brake Fluid Level Warning Switch -F34-.
-- Remove the brake fluid reservoir cover over the brake fluid reservoir. Refer to BRAKE FLUID RESERVOIR COVER, REMOVING AND INSTALLING .
-- To protect against escaping brake fluid, place enough lint-free cloths in the area below the master brake cylinder.
-- Siphon as much brake fluid as possible using the Brake Charger/Bleeder Unit VAS5234 and Adapter VAS5234/1 from the brake fluid reservoir.
-- With manual transmissions, remove the clutch hydraulic line -5- from the brake fluid reservoir and seal it.
- Brake fluid must never come into contact with fluids containing mineral oils (oil, gas, cleaning solutions). Mineral oil damages the plugs and sleeves in the brake system.
- Brake fluid is poisonous. NEVER siphon brake fluid with your mouth! Also due to its corrosive effect, brake fluid must not come into contact with paintwork.
- Observe the disposal regulations.
-- Pull the lower locking pin out of the brake fluid reservoir.
-- Remove the brake fluid reservoir from the brake master cylinder.