Overview - Cover And Padding, Divided Rear Seat Backrest With Pass-Through

NOTE:

The illustration only shows the structure of the right 2/3 section of the rear seat backrest. The structure of the left 1/3 section of the rear seat backrest is similar.

Fig 1: Overview Of Cover And Padding, Divided Rear Seat Backrest With Pass-Through

Courtesy of AUDI OF AMERICA, LLC

Molding
- Sewn into cover
- For engaging the cover in the backrest shell
Cover
- Removing and installing. Refer to BACKREST COVER AND PADDING, REMOVING AND INSTALLING, DIVIDED REAR SEAT BACKREST WITH PASS-THROUGH .
- Separate the cover from the padding. Refer to COVER AND PADDING, SEPARATING, REAR SEAT BACKREST WITH PASS-THROUGH
Molding
- Sewn into cover
- For engaging the cover in the backrest shell
Retaining Channel
- Sewn into cover
- For engaging the cover in the backrest shell
Cushion
- Removing and installing. Refer to BACKREST COVER AND PADDING, REMOVING AND INSTALLING, DIVIDED REAR SEAT BACKREST WITH PASS-THROUGH .
- Separate the cover from the padding. Refer to COVER AND PADDING, SEPARATING, REAR SEAT BACKREST WITH PASS-THROUGH
Outer Bracket
Backrest Shell
Trim
- For locking
- Removing and installing. Refer to LOCKING MECHANISM TRIM, REMOVING AND INSTALLING .
Rear Center Belt Guide
- Replace the entire belt guide if damaged.
- Removing and installing. Refer to REAR SEAT BELT GUIDE, REMOVING AND INSTALLING, CENTER REAR SEAT BELT GUIDE, FOLDING REAR SEAT BACKREST .
Headrest Guide
- Removing and installing. Refer to HEADREST GUIDE, REMOVING AND INSTALLING .
Cover Frame
- Only on the right 2/3 split backrest with pass-through
- Removing and installing. Refer to COVER FRAME, REMOVING AND INSTALLING .
Inner Bracket
Clip
- Covered in foam padding
Clip
- Covered in foam padding
- Only with fabric covers
Cushion Clip
- Only with leather covers
- For securing the cover to the padding
- Always replace if removed
- Install in same location as before removal
Molding
- Only on the right 2/3 split backrest with pass-through
- Sewn into cover
- For engaging the cover in the pass-through opening
Plugs
- For securing the cover
- Quantity: 2
Molding
- Only on the right 2/3 split backrest with pass-through
- Sewn into cover
- For engaging the cover in the pass-through opening