LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> RS 7 >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine System (Cylinder Head & VALVETRAIN - Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC)) >> Cylinder Head, VALVETRAIN >> VALVETRAIN >> Valve Stem Seals, Removing And Installing >> Valve Shaft Seals, Removing And Installing, Cylinder Removed >> Assembling

Valve Shaft Seals, Removing And Installing, Cylinder Removed: Assembling

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Assembly is performed in the reverse order of disassembly, noting the following: 

-- Make sure all the roller rocker levers lie on the ends of the valve stems correctly and are clipped onto the respective hydraulic adjusting elements.

-- Install the intake manifold. Refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals