Overview - Cylinder Head: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The cylinder head for cylinder bank 2 (left) is shown in the illustration.
- Cylinder Head Gasket
- Always replace. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
- Installed position: Parts number to cylinder head
- Change the coolant and engine oil after replacing
- Cylinder Head
- Removing and installing. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
- Check for distortion. Refer to Tightening Specifications
- Reworking dimension. Refer to Tightening Specifications
- Change the coolant and engine oil after replacing
- O-Ring
- Always replace
- Front Coolant Pipe
- Removing and installing. Refer to FRONT COOLANT PIPE, REMOVING AND INSTALLING .
- Bolt
- Tightening specification -Item 17- OVERVIEW - COOLANT PIPES .
- Bolt
- 22 Nm
- Engine Lifting Eye
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Always replace
- Loosening sequence. Refer to CYLINDER HEAD BANK 2 (LEFT), REMOVING
- Bolt
- 22 Nm
- Engine Lifting Eye
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Always replace
- Loosening sequence. Refer to CYLINDER HEAD BANK 2 (LEFT), REMOVING
- Oil Screen
- Clean
- Partition Plate