After-Run Coolant Pump -V51-, Removing And Installing, Version 1: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2014 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Loosen the hose clamps -arrows- and remove the air duct hose.

Fig 1: Air Intake Hose Components

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -5-.

Fig 2: Removing And Installing After-Run Coolant Pump -V51- (Non-Hybrid Vehicles With Engine Code CDZA)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -4- free up the Ground Wire, and then remove the double bolt.

-- Remove the nut -2-.

-- Loosen the hose clamps -3-, then clamp off the coolant hoses with the :3094 and then remove them.

-- Remove the bolts -1- and the After-Run Coolant Pump -V51-.