LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> RS 5 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Cooling System [CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB] (Cabriolet)) >> 19 Cooling System >> Coolant Pump/Coolant Thermostat >> Coolant Valves, Removing And Installing >> Removing

Coolant Valves, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2014 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING / OVERVIEW - NOISE INSULATION .

-- Disconnect the connector -2-.

Fig 1: Transmission Coolant Valve -N488- Component Location
GWWA19-11641Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -1-, then clamp off the coolant hoses with the :3094  and then remove them.

-- Remove the nuts -arrows- and then remove the Transmission Coolant Valve -N488-.

scientia non olet · About LEMON Manuals