Overview - SUBFRAME Mount

Fig 1: Exploded View Of Subrframe Mount

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 20 Nm
Retaining Plate
- For the engine mount
- If the engine mount is faulty, replace the retaining plate
- Check the retaining plate on the opposite side; replace if necessary
Stop Buffer
- Not available individually
Bolt
- 40 Nm
Engine Support
Bolt
- 10 Nm
Heat Shield
Not Installed
Not Installed
Bolt
- 90 Nm +90° turn
- Replacing
Engine Mount
- Left with the Left Electrohydraulic Engine Mount Solenoid Valve -N144-
- Right with the Right Electrohydraulic Engine Mount Solenoid Valve -N145-
- Removing and installing: Left engine mount. Refer to LEFT ENGINE MOUNT, REMOVING AND INSTALLING , right engine mount. Refer to RIGHT ENGINE MOUNT, REMOVING AND INSTALLING
- Replace in pairs
Subframe
Bolt
- 55 Nm
Bolt
- 55 Nm