| All Wheel Drive Clutch Valve to Hydraulic Control Unit Housing Bolt |
- |
2.5 |
| All Wheel Drive Pump to Hydraulic Control Unit Housing Bolt |
- |
5 |
| Automatic Transmission Fluid Drain Plug to Final Drive Housing |
- |
15 |
| Automatic Transmission Fluid Inspection Plug to Left Chamber |
- |
15 |
| Bracket for the Wiring Harness |
|
9 |
| Center Bearing |
- |
20 |
| Drive Axle Heat Shield to Rear Final Drive Bolt |
- |
20 |
| Driveshaft Center Bearing to Body Bolt |
- |
20 |
| Driveshaft to Rear Final Drive Flange Bolt 1 |
- |
30 + 90° |
| Driveshaft to Transmission Flange Bolt 1 |
- |
30 + 90° |
| Flange Shaft to Rear Final Drive Bolt 1 |
- |
50 + 180° |
| Gear Oil Inspection Plug to Final Drive Housing |
- |
15 |
| Hydraulic Control Module to Final Drive Housing Bolt |
| |
M8 2 |
20 |
| |
M8 3 |
20 |
| |
M8 4 |
30 |
| Left Pipe Installed between the Hydraulic Control Unit and the Left Chamber, Nuts |
- |
30 |
| Left/Right Chamber to Final Drive Housing Bolt |
- |
24 |
| Oil Pressure/Temperature Sensor to Hydraulic Control Unit Housing |
- |
10 |
| Right Pipe Installed Between the Hydraulic Control Unit and the Right Chamber, Nuts |
- |
30 |
| Shuttle Valve to Hydraulic Control Unit Housing |
- |
8 |
| Subframe to Rear Final Drive |
| - Lower Bolt |
- |
55 |
| - Rear Bolt |
- |
95 |
| Wiring Harness Bracket to Right Chamber Bolt |
- |
5 |
| Wiring harness bracket to the rear final drive |
- |
9 |
- 1
Always replace
- 2
50 millimeter (mm) long
- 3
50 millimeter long, with a permanent seal under the bolt head
- 4
30 mm long
|