Driveshaft To Rear Final Drive - Tightening Specification And Sequence

Always replace the driveshaft bolts -1-.

Fig 1: Counterholding Using Counterhold Tool Touareg V10 T10172 And Adapters T10172/5
Courtesy of AUDI OF AMERICA, LLC
Counterhold using the counterhold Tool Touareg V10 T10172 and adapters T10172/5.

-- Tighten the bolts -1- in 3 steps as follows:

Step	Bolts	Tightening Specification/Additional Turn
1.	-1-	Next to the color dots 30 Nm ¹⁾
2.	-1-	The remaining all around 30 Nm
3.	-1-	90° additional turn all around
¹⁾ The CV joint will be pushed toward the opposite side reducing the imbalance.