LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> RS 5 Base >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Final Drive, Differential - Rear Final Drive 0BF & 0BE (Coupe) >> Final Drive, Differential >> Removal And Installation >> Flange Shaft Seals, Rear Final Drive Removed >> Removing

Flange Shaft Seals, Rear Final Drive Removed: Removing

-- Follow the general repair instructions. Refer to the appropriate service information.

-- Remove rear final drive. Refer to REAR FINAL DRIVE .

-- Remove the flange shaft bolt. While doing this, install the two bolts into the flange counter hold the flange shaft using a tire iron.

Fig 1: Identifying Flange Shaft Bolt, Removal
GWWA39-10380Courtesy of AUDI OF AMERICA, LLC

-- Remove the flange shaft.

NOTE:

Use the VW 771 to remove the flange shaft if it is not possible to remove it manually.

-- Remove the flange shaft seal using the VW 771 and the additional part for the slide Hammer VW 771/37.

Fig 2: Identifying Flange Shaft Seal, Removal
GWWA39-10381Courtesy of AUDI OF AMERICA, LLC