Flange Input Shaft Ring, Replacing, 0BC

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S6, 2015 Audi A6 Quattro, 2014 Audi S6, 2014 Audi A6 Quattro, and 2013 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

The ring can only be replaced with the input shaft removed.

Special tools and workshop equipment required

Needle Bearing DriftVW 295 A
Thrust PlateVW 402
PunchVW 408 A
Support ChannelsVW 457
-3- Separating Tool 22 to 75 mm, for example, Kukko Separating Tool 12-75 mm17/1

Input shaft removed. Refer to INPUT SHAFT SEAL, REPLACING, 0BC .

Fig 1: Identifying Ring -A- From Flange/Driveshaft, Removal

Courtesy of AUDI OF AMERICA, LLC

B - Separating tool 12 to 75 mm, for example Kukko Separating Tool 12-75 mm17/1

Fig 2: Identifying Flange And Groove Position

Courtesy of AUDI OF AMERICA, LLC

The ridge -arrow 1- on the ring -A- must fit into the groove -arrow 2- on the flange -B-. The smaller outer circumference -arrow 3- faces the flange.

Fig 3: Identifying Ring -A- Onto Flange/Driveshaft, Installation

Courtesy of AUDI OF AMERICA, LLC

The ring -A- must fit into the groove all around the flange. Refer to Fig 2.